5
2. Quick Operating Guide
The XR6 is shipped from the factory with no batteries installed. The first step is to install 4 “AA”
batteries. These may be alkaline or rechargeable types. To install batteries, remove the battery
door located on the back of the caller.
The door is attached to the XR6 with a
knurled thumbscrew (see figure 1).
Orient the batteries as per the
directions shown in each cavity with
the holder. Note that the battery
polarity alternates. Replace the
battery door after the batteries are
installed.
The TX5-LR transmitter operates from
a 9V battery. Please use a high quality
alkaline battery. To install the battery, remove the battery compartment cover located on the
rear of the transmitter. Connect the 9V battery to the connector plug and orient the battery in
the transmitter. Replace the battery compartment cover.
Please note that the XR6 can only be operated from the TX5-LR remote control. Make sure that
at least one of the speaker selector slide switches is set to the right, or “On” position. Turn the
power On/Off switch to the “On” position. This switch also presents the maximum volume that
can be obtained from the remote control. For example, if you turn the rotary preset volume
control to halfway, you will only ever be able to get half volume from the remote control. The
further clockwise you turn the knob; the unit will play from the remote control. The green “Low
Battery” LED will blink for several seconds while the microprocessor sets up the internal
operating parameters. If the LED continues to blink, check the batteries for a reversed or weak
battery. Select the sound that you choose to play by depressing the “Sound Up” or “Sound
Down” keys on the TX5-LR remote control (you can push and hold the buttons, or push them
one at a time) until your desired sound number appears in the LCD display. Note that the
sounds are listed on the back of the TX5-LR transmitter, and each sound is assigned a specific
number. Push the send button on the TX5-LR transmitter before the display turns off.
TIP: When depressing keys on the TX5-LR transmitter, be sure to hold for approximately one
second prior to releasing. This will ensure that the signal is sent to the main unit. Quick button
presses may not fully send the signal to the XR6.
Because the XR6 sets the remote control volume to minimum on power-up, you must increase
the volume by using the “Volume Up” button on the remote. Push and hold this button until the
volume reaches the desired level. If no sound is heard, make sure that a speaker switch is
turned on, and that the volume control on the side of the XR6 is turned up. To lower the volume
(27 páginas)
(40 páginas)
(94 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais