Abit TX5 Guia do Utilizador descarregar pdf (Página 33)

4 Getting Started

Charging the battery

The PowerBlock battery can be charged in the laser scanner or in the PowerDock battery charger

which is available as an optional accessory. Carefully read the safety measures described in

PowerBlock battery safety, page 14 and PowerDock battery charger safety, page 15 before using

them.

It is recommended to fully charge the battery before use and that a spare battery is kept on hand

just in case it is needed during your scan project.

Charging the battery in the laser scanner

The laser scanner doesn't need to be switched on in order to charge the battery.

1. Mount the battery into the laser scanner. See Supplying power with the battery, page 38.

2. Connect the AC adaptor to the laser scanner and the wall outlet. See Supplying power with the

external power supply unit, page 39.

3. If the laser scanner is turned off, the upper LEDs on both sides of the scanner as well as the

LEDs at the scanner mount will start blinking slowly yellow while charging. The LEDs will stop

blinking and will illuminate constantly yellow when the battery is fully charged.

4. If the laser scanner is turned on, you can check the exact charge state of the battery in the

scanner's user interface under Manage / General Settings / Power Management.

Please note:

Take out the laser scanner from the transport case before connecting the power supply to the

scanner.

Use the power supply unit indoors only.

Before longer storage, remove the power supply unit and the battery from the laser scanner.

Tips for using the battery

Charge the battery the day it is to be used or on the day before. A charged battery unused will

gradually lose power over time.

If the battery becomes exhausted quickly after being fully charged, replace it with a new one.

For best battery performance, an ambient temperature of 5°C (41°F) to 35°C (95°F) is recommended.

In colder or warmer locations, battery performance and operation time may temporarily decrease.

Charging the battery with the PowerDock battery charger

The charger can be used in foreign countries. It is compatible with a 100 V AC to 240 V AC 50/60 Hz

power source. Use a plug adapter for other countries.

Trimble TX5 3D Laser Scanner User Guide 33

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 124 125

Sem comentários

Abit TX5 Guia do Utilizador Página 33